Amateur Radio Stuff: What’s Going On

It’s been quite a while since I mentioned mentioned amateur radio, but that’s been because of a lack of time, not a lack of interest. Things back in the radio room are about to get — interesting, as they say. I’m facing a situation that every amateur radio operator does sooner or later, having to tear down everything.

IMG_0356

It’s even worse than this looks here. There are two more desks crammed into that room, an old drafting table, three book cases, a work table… It’s bad.

The radio room is, to put it bluntly, a mess. There is equipment piled everywhere, test gear shoved onto book cases or in drawers, amplifiers and radios laying on the floor, piles of printouts of manuals, booklets, stacks of mystery electronics in those anti-static bags, drawers full of connectors and parts, coax jumpers, meters, microphones, tools three full sized computers, three printers, all my Raspberry Pi stuff. There are cables and wires snaking along behind the desks, running into holes in the floor. The operating position is too cramped and awkward. The old drafting table my solid state amp is parked on it is too tall and too small, the desk the radios are on is in poor condition. The list goes on and on.

So everything is going to get torn down, moved out of the room. The room is going to get a good cleaning, etc. Then I start trying to put everything back together.

What sparked this is that MrsGF found a huge old teacher’s desk, made out of solid oak, for $50 at St. Vinnie’s. MrsGF already has one of these and I’d been looking for one for a while. The finish isn’t very good and it has it’s share of scratches and scars, but it is rock solid, lots of big drawers, and is long, wide and deep. That is going to get moved in, some of the old, particle board crap I’ve been using is going to go away before it collapses under the weight of the equipment, and then I can start trying to put everything back together again.

If I can remember how to do it… Meters, jumpers, wires, coax. You’d think I’d know enough to label all that stuff, right? I mean I have a label maker laying right there. But no, of course I didn’t. Sigh…

Anyway, Monday is the day when I start all of this. It’s taken me three years to accumulate this mess and put together that rat’s nest of wiring behind the desks, so this could take a while…